Rear light: Installed on the bike pipe
Yellow turn left signal
Yellow turn right signal
Red light
USB port
Laser light
Extended press to turn on/off
Short press to change mode
Rotating Axis
Battery cover
Controller:
Extended press“！” to turn on/off light
Short press“！” to change red light modes
Laser Steady/Flash/OFF
Turn left
Turn right
Installation
2.Hold the tail light holder into the seat tube as shown in Figure B and lock the holder with a Phillips
screwdriver.
4.Picture D, Blue arrow is axis of rotation could adjust light angle.
Installed under saddle
1. Put screws through the plastic part and nut. 2. Connect light with plastic part. Then put then
under saddle like shown.
3. Put another plastic part under it. 4. Tighten the two screws.
This fix way could not take down light to charge for anti-theft. if you want to easy take down, you
only need reverse install the plastic part.
Install of controller
Use rubber band fix the controller on
the handlebar.
-8- -9-
！
LASER
To Next Page
Loading...
