Melcom K6600 User Manual

Mounting onto wall
Using the rear keypad plastic case
as a template, mark the positions
of the mounting holes. The
mounting surface must be solid, do
not mount onto a flammable or
uneven surface. Drill mounting
holes and fit wall plugs, before
drilling make sure you wear safety
goggles and check for hidden cable
and pipes.
K6600
43215
98760
PROG
MEN OMIT RESET SET
Opening the keypad
To remove the front cover, insert a
flat headed screwdriver to release
the pegs located at the bottom of
the keypad.
K6600 LCD Keypad Installation Instructions
Description
The K6600 LCD keypads can be connected to both the ST6100 & ST6600 control
panel. Up to a maximum of 6 Keypads can be connected to anyone control panel. The
keypad features, 32 segment LCD display, back light illumination, power, system status
and omit LED indication, onboard personal alarm (press: SET, OMIT, SET).
Installation instructions:
Handling the keypad
l Make sure your hands are clean
l Handle keypad carefully the LCD display is fragile
l Do not use unnecessary force when opening and closing the plastic case
l Peel off the protection film covering the LCD display
l Set the addressable configuration jumpers
l Install the keypad close to your entry/exit point of the building,
it should be positioned out of reach of children.

Melcom K6600 Specifications

General

Brand	Melcom
Model	K6600
Type	Keypad
Standby Time	Up to 120 hours
Expandable Memory	MicroSD up to 8GB
FM Radio	Yes
Bluetooth	Yes
Network	GSM
Display	1.8 inch

Summary

Installation Instructions

Handling the Keypad

Keypad handling guidelines including cleanliness, care for the LCD, plastic case, protection film, jumpers, and placement.

Opening the Keypad

Instructions on how to remove the front cover using a flat-headed screwdriver to release the pegs.

Mounting onto Wall

Contrast Adjustment

Configuring Address Setting

Address Table

Table detailing address settings for keypads and accessories, crucial for proper communication with the control panel.

Wiring Terminal Block

Closing Keypad

Specifications

Operation