3
Vents and drains are located at the bottom of the equipment. It is forbidden to place items at the bottom of the cabinet.
Do not place the equipment in areas exposed to the sun or rain, so as to prevent danger such as short circuit or
overheating.
Do not tilt or lay the equipment sideways, and do not impact the equipment body; Refrigeration systems are installed in the
equipment, which is easy to be damaged by tilt or impact.
Please place the equipment in a dry and dust-free environment to avoid risks such as overheating, and short circuit.
In case of unexpected sound, smell, smoke, etc. when the power is turned on, please unplug the power in time and contact
the manufacturer or supplier.
Please place the equipment in a dry and ventilated environment, and ensure that the equipment vents and instrument
surfaces are not blocked or shielded by walls or other objects; Do not use it in a poorly ventilated environment to prevent
damage caused by heat released by equipment.
It is forbidden to disassemble and modify this equipment without authorization, so as to avoid potential safety hazards. In
this case, MELING BIOMEDICAL will not bear any responsibility for quality accidents.
It is forbidden to put inflammable and explosive dangerous goods, strong corrosive acids, alkalis and other items
unsuitable for the equipment in the equipment.
When storing toxic, harmful or radioactive materials, please use the equipment in safe areas. Improper use may cause
harm to human health or environment.
Metal objects such as nails or iron wires shall not be inserted into any aperture and gap or any outlet of the equipment,
otherwise electric shock or injury may be caused due to accidental contact between the above objects and moving parts.
In order to ensure the normal operation and ventilation and heat dissipation of the equipment, the back, left and right sides
of the cabinet body should be at least 30cm away from the wall, and the air inlet and air outlet must not be blocked by
obstacles.
This equipment must be connected to a ground wire.
Note: Failure to observe the precautions may result in personal injury or equipment failure and related
property losses.
It is forbidden to store living animals, flowers or other items with strict temperature requirements in the equipment.
When the equipment is running, do not touch the inner surface of the cabinet without wearing protective gear.
Hold the handle and close the door to avoid pinching your fingers; When the equipment is not used for a long time, please
unplug it and pack it for storage.
When restarting the equipment after power failure or power off, please check the equipment settings first, otherwise the
stored items may be damaged due to the change of settings.
The equipment can be used for item preservation, not as production equipment.
Keep the keys properly, so as to avoid accidents when children open the door accidentally.
When handling the equipment, please be careful not to tip over the equipment, so as to prevent equipment damage or
personal injury.
When handling, it shall be lifted from the bottom, with the inclined plane not be greater than 45°, and it shall be handled
with care. Please use the equipment in safe areas. Improper use may cause harm to human health or environment.
2
2. Safety Instructions
When using this product for the first time, please pay attention to the meaning of the following warning signs
and carefully read the safety precautions, so that you can use this equipment safely and correctly.
Warning: Failure to observe the precautions may result in serious personal injury or death.
Do not touch the equipment with wet hands to avoid electric shock; Equipment shall not be grounded through gas pipeline,
water supply pipeline, telephone line or lightning rod, which may easily cause electric shock.
This equipment can only be installed by professional technicians or after-sales maintenance personnel, it may cause
electric shock or fire.
Be sure to install the equipment on a solid and flat ground and take due care to prevent tipping over. If the ground is not
solid enough or the installation location is not appropriate, it may cause the equipment to fall over and cause equipment
damage or personal injury.
Don't bundle the power cord, don't press it under furniture or heavy objects, and don't get close to heat sources such as
compressors.
Please handle the power cord carefully to avoid short circuits or open circuits. Please turn off the power before pulling out
the power plug. Hold the power plug carefully and pull it out. Do not pull the wires of the power plug. Otherwise, it may
cause electric shock or fire due to the short circuit.
Please insert the power plug into the outlet tightly to ensure firmness and reliability, so as to avoid electric leakage; After
installation, the power plug must be within reach, so that the power cord can be unplugged in time in case of emergency.
Separate special outlets must be used and grounded reliably. The cross-sectional area of the copper conductor in the wall
2
connected with the outlet must be more than 4mm . Do not lengthen the power cord without authorization to avoid heating
or fire.
Do not use the power supply that is not specified in the equipment design, so as to avoid overheating, short circuit and
other faults. For example, connecting 110V rated voltage products to 220V power supply may cause faults such as
overheating and equipment burning. For detailed input voltage AC please refer to Specification(Rated voltage ±10%).If the
operating voltage is too low or too high, a suitable automatic voltage stabilizer must be installed for cooperative use.
Please place the equipment stably and avoid shaking.
Do not place the equipment in a dangerous area, and do not operate the equipment near flammable items to prevent
explosion or fire accidents.
Warning: Risk of fire/flammable materials.
Warning! Failure to observe the precautions
may result in serious personal injury or death.
Attention! Failure to observe the precautions
may result in personal injury or equipment failure
and related property losses
Risk of Exploration This sign indicates the risk of
explosion when using volatile and explosive chemicals.
Do not place it obliquely
Beware of electric shock.
Beware of low temperature
Beware of fire.Warning;flammable material
This equipment is a precision instrument
Warning; crushing of hands.
To Next Page
Loading...