EasyManuals Logo

Melitta LOOK Selection User Manual

Melitta LOOK Selection
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
8
cleaning.
•Duringoperation,partsofthe
appliance such as the steam outlet
at the filter become very hot.
Avoid touching these parts and
avoid contact with hot steam.
•Donotopenthelterholder
during brewing.
•Thehotplatebecomesveryhot
during use and remains hot for
a long time after the brewing
process. Contact with the hot
plate can cause burns, so avoid
touching it.
•Makesurethatthepowercable
does not touch the hot plate.
•Donotusetheapplianceifthe
power cable is damaged.
•Donotallowthepowercable
to come into contact with liquids.
•Neverimmersetheappliancein
water.
•Donotusethejuginthe
microwave.
•Donotcleanthepartsthat
come into contact with food
with aggressive cleaning agents
or scouring cream. Remove
detergent residues with clean
water. Further information on
cleaning can be found under
Cleaning and care“.
•Thisappliancecanbeusedby
children from 8 years of age or
older if they are supervised or
have been instructed in the safe
use of the equipment and have
understood the potential hazards.
Cleaning and maintenance must
not be carried out by children,
unless they are 8 years or older
and are supervised. Keep the
appliance and the power cable
away from children under 8 years
of age.
•Theappliancemaybeusedby
persons with reduced physical,
sensory or mental abilities or lack
of experience and/or knowledge
if they are supervised or have
been instructed in the safe use of
the appliance and have understood
the potential hazards.
•Childrenmustnotplaywiththe
appliance
•Replacementofthepowercable
and all other repairs may only be
carried out by Melitta
®
Customer
Service or by an authorised
repair shop.
2. Before rst use
•Ensurethatthepowersupplyinyourhomecorresponds
to that on the model plate on the base of the appliance.
•Connecttheappliancetoapowersource.Unused
cable can be stored in the base of the appliance .
•Allapplianceshavebeentestedduringproduction
for perfect functioning. Therefore there may be
for example water deposits remaining. Rinse the
appliance twice with the maximum amount of water
and without a filter bag or ground coee, in order to
clean it.
•Forthebestcoeeenjoymentandconvenientuse,
the appliance is equipped with various features.
These features are explained below.
3. Set water hardness
Depending on water hardness lime scale may build up
in the appliance. This increases the appliances energy
consumption as lime scale on the heating element can
prevent the water heating eectively. To avoid damage
the appliance must be descaled regularly. The descaling
display helps you in this. If the CALC-button is
permanently lit this shows that the appliance needs to
be descaled.
The appliance is pre-set for a high level of water
hardness (level 4). You can find out the level of water
hardness in your area by asking your local water
provider or by using water hardness measuring strips
available in the shops. For softer water the descaling
display can be adjusted to descale less often:
•HolddowntheCALCbutton for longer than 2
seconds. The CALC button starts to flash. In the
factory settings the CALC button flashes briefly four
times with the following pauses ………
•Youcansetthewaterhardnessatthreefurther
levels. Each time you briefly press the CALC button
 GB

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Melitta LOOK Selection and is the answer not in the manual?

Melitta LOOK Selection Specifications

General IconGeneral
Product typeDrip coffee maker
Water filterYes
Capacity in cups10 cups
Coffee input typeGround coffee
TypeCoffee
Coffee temperature after brewing93 °C
Product colorBlack, Stainless steel
Built-in displayNo

Related product manuals