Melitta One:One MES2B User Manual

10
5. Place the empty Pod Holder inside the Pod Chamber, see
Figure 7.
Note: When brewing coffee or tea, use the black pod holder
for coffee and the grey pod holder for tea.
6. Place one Melitta
®
javapod
™
or Cooper’s
®
teapod
™
inside the
Pod Holder. Press lightly on the javapod
™
or teapod
™
to make
sure it sits evenly in the Pod Holder. See Figures 10 and 11
for correct pod insertion.
CAUTION: Use only specially designed Melitta
®
javapods
™
or
Cooper’s
®
teapods
™
in your One:One
™
Pod Brewing System.
The use of loose ground coffee, pods or tea bags not designed
for the One:One
™
, may result in poor coffee or tea, and could
possibly damage the machine.
CAUTION: Never use torn javapods or teapods as this could
clog the machine and damage it. Each javapod or
teapod is pre-portioned with the optimal amount of coffee or tea
required per cup.
7. To close the Lid, press down firmly on the top of the Lid and hold
in place while pushing the Lever back so it is flush with the Lid
and locks into place.
8. Place a mug or cup under the Drip Spout.The cup should hold
at least 7 to 10 ounces, depending on your selection. To make
iced or hot tea, place the appropriate spout inside the
One:One
™
.
9. When the indicator light stops flashing, the appliance is ready
to use. If the indicator light flashes at rapid intervals, see
Troubleshooting on page 14.
FIGURE 10
Bulging end of
pod faces
down
FIGURE 11
correct incorrect

Melitta One:One MES2B Specifications

General

Brand	Melitta
Model	One:One MES2B
Category	Coffee Maker
Language	English