EN
Description
A – Short suspension tube
B – Long suspension tube
C – Ceiling bracket cover
D – Body cover
E – Ceiling bracket
F – Motor
G – Remote control receiver
H – Blades
I – Remote control
J – Remote control support
REMOTE CONTROL
1 – Speed 1/2/3/4/5/6
2 – On/o button
3 – Rotation direction change
button
4 – Timer 1/2/4/8 hours
5 – Night mode
6 – Airow mode button
If the model of your appliance does
not have the accessories described
above, they can also be bought
separately from the Technical
Assistance Service.
Installation
Be sure to remove all packaging
material from inside the appliance.
Ensure that the fan is switched
o from the supply mains before
start any installation or assembly
operation.
Take the motor out of the
packaging. To avoid damaging the
housing surfaces, mount the motor
on a soft surface.
–
–
–
–
–
–
––
–
–
–
–
–
In order to avoid electric shock,
make sure that the power supply
has been previously disconnected.
The electrical installation must be
done in accordance with current
regulations, connecting the fan to
ground as a precaution against
eventual electric shock.
It is recommended that the
installation be done by a
professional.
Install the fan at a minimum
distance of 2,50 meters from the
ground or other objects.
FAN INSTALLATION
See “FAN INSTALLATION” at the
beginning of the instruction manual.
IMPORTANT: In the package, you
will nd the material for xing the
bracket to the ceiling. This material
is not suitable depending on what
type of roof. Ask a professional and
use the xing means that you think
are the most suitable.
ASSEMBLING THE BATTERY/S
Caution: During the handling
of batteries, do not touch both
poles at the same time, as this
will provoke the partial discharge
of the stocked energy therefore
aecting longevity.
Remove the cover of the battery
compartment.
Check that the plastic covering
that protects the battery has been
removed (some batteries are sold
with a protective covering)
To Next Page
Loading...