Memphis SRX150.2 - Page 19

S eaker Connections Continued
Speaker have a positive and negative marking on the terminals. These are used to indicate polarity and must be
considered when wiring speakers or subwoofers to an amplifier. Amplifiers also have positive and negative
markings on their speaker outputs. Use these markings to match polarities to ensure the speakers are in phase.
Failure to wire speakers or woofers in phase with one another will result in a loss of bass. All Street Reference
amplifiers require a minimum 20 impedance in stereo or QO in mono [bridged) mode .
2 Channel Model SRX150.2
0
FUSE
PO W ER ~
!IU.'f'
0
~.W" 11
, ..
B,m • REMOTE GNO
POWER
l~~I
g
20 HM M ii~
R·
R•
20HMMIN
Gl
0---•m .. • ... --¢
RJSE
"""'
0 R = 0 l =
~
BATT•
REMOTE
, ..
POWER
µ@WSM~I
0
~Cl
''"
g
0
L·
I.I OHM MIN
R•