Need help?Do you have a question about the Memphis SRX250.1 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Crossover Slope | 12dB/Octave |
| Bass Boost | 0-12dB |
| Fuse Rating | 25A |
| RMS Power @ 2 Ohms | 250W x 1 |
| Impedance | 4 Ohms |
| Frequency Response | 10Hz - 180Hz |
| Low Pass Crossover | 50Hz - 180Hz |
| Input Sensitivity | 200mV - 4V |
| Power Output (RMS) | 250 Watts |
Covers high/low level inputs, 2-ohm stability, 4-ohm mono, and switchable Bass Boost feature.
Details the variable Subsonic filter (15Hz-50Hz) and variable Low Pass filter (30Hz-250Hz) for audio tuning.
Explains protection circuitry, LED indicators, and the included remote level control for operation and safety.
Provides guidance for common issues like no output, weak output, and unwanted noise.
Details connecting the 12V+ to the battery post with specific wire gauge and fuse requirements per model.
Explains making a direct chassis ground connection with appropriate wire size and preparation.
Describes connecting the remote turn-on lead to the source unit or power antenna output.
Explains the gain control, emphasizing it's not a volume control and its function for amplifier output.
Details the LPF function, frequency range (30Hz-250Hz), and its use for mid-bass and subwoofers.
Covers the switchable Bass Boost and the variable Subsonic Filter for audio tuning.
Explains the input for the Remote Level Control (RLC) for adjusting amplifier input level from the driver's seat.
Instructions for connecting RCA jacks to low-level outputs of the source unit or signal processor.
Mentions the availability of high-level (speaker-level) inputs as an alternative connection method.
Lists specific exclusions from the product warranty, including improper installation, misuse, and cosmetic damage.
Details warranty exclusions like improper installation, misuse, accidents, and unauthorized service.
To Next Page
