Memphis SRX150.2 - SRX150.2 Speaker Wiring Modes; Stereo Mode Wiring; Mono Mode Wiring

8
SPEAKER CONNECTIONS CONTINUED
Speaker have a positive and negative marking on the terminals. These are used to indicate polarity and must be
considered when wiring speakers or subwoofers to an amplifier. Amplifiers also have positive and negative
markings on their speaker outputs. Use these marking to match polarities to ensure the speakers are in phase .
Failure to wire speakers or woofers in phase with one another will result in a loss of bass . All street reference
amplifiers require a minimum 2ohm impedance in stereo or q ohms in mono [bridged) mode.
STEREO MODE
MONO MODE
2 Ch Model (SRX 150.2)
FUSE
P;R ~iJ.
PROTECT
[R ED I
20A
R·
R+
FUSE
P;R ~iJ.
PROTECT
IR EO I
20A
L·
R+
POWER
BATT+ REMOTE GND
20HM MIN
20HM MIN
POWER
BATT+ REMOTE GNO
q OHM MIN