Menuett 005359 - Battery Temperature During Charging; Battery Overheating Protection

EN
31
protect the battery. Charging resumes
when the surface temperature of the
battery is between 0 and 45°C. The battery
will not charge if the surface temperature
of the battery is higher than 45°C.
Discharging
• The four status lights go o one by one
when the battery discharges. Only the last
status light is ashing when 8% of the
battery charge is left to show that the
battery must be charged.
• If the surface temperature of the battery is
higher than 70°C during use the four
status lights ash for ve seconds, after
which the power supply to the vacuum
cleaner is disconnected to protect the
battery. The power supply is reset when the
surface temperature drops below 65°C.
WORK LIGHT
The LEDs on the nozzle for the work light are
controlled by the surrounding light and only go
on in the dark.
MAINTENANCE
EMPTYING/CLEANING
1. Release the accessory by pressing the
release button.
FIG. 6
2. Press the release button to open the lid
over the dust container and empty the dust
container.
FIG. 7
3. Release the dust container by pressing the
release button. Brush the intake with a
small brush.
FIG. 8
4. All parts must be dry before tting them.
FIG. 9
5. Press the release button to open the cover
over the HEPA lter.
FIG. 10
6. Remove the HEPA lter and wash under
running water.
7. Allow it to completely dry before retting
and using. If necessary, open the front
cover and insert a new HEPA lter.
FIG. 11
Fitting components
1. First replace the dust container on the
vacuum cleaner.
2. Fit the HEPA lter and tube with the nozzle
or accessory.
FIG. 12
Cleaning the rotating brush
If the rotating brush is blocked the capacity of
the vacuum cleaner will be reduced and the
brush must be cleaned.
1. Switch o the vacuum cleaner and
carefully remove with a pair of scissors or a
sharp knife threads and hair etc. that have
fastened around the brush.
2. If necessary, remove the rotating brush by
pressing the catch underneath the brush
with your ngers, or a coin.
3. Remove and clean the rotating brush.
4. Replace the rotating brush.
5. Press the catch in place with your ngers.
NOTE:
Remove the battery before cleaning or
removing/tting the rotating brush.