Merach MR-S19 - Function and Operations

Function and Operations :
1.SCAN:
Press"MODE"buttonuntil"SCAN"appears,monitorwillrotatethroughallthe5~6functions.
Time,speed,distance,calorie,ODOandpulse.Eachdisplaywillbehold6seconds.
2.TIME:
(1)Countthetotaltimefromexercisestarttoend.
(2)Press"MODE"buttonuntil"TIME"appears,press"SET"buttontosetexercisetime.
Whenthe"SET"iszero,themonitorwillalarm10seconds.
3.SPEED:
Displaycurrentspeed.
4.DIST:
(1)Countthedistancefromexercisestarttoend.
(2)Press"MODE"buttonuntil"DIST"appears,press"SET"buttontosetexercisedistance.
Whenthe"SET"iszero.
5.CALORIES:
(1)Countthetotalcaloriesfromexercisestarttoend.
(2)Press"MODE"buttonuntil"CAL"appears,press"SET"buttontosetexercisecalories.
Whenthe"SET"iszero,themonitorwillalarm10seconds.
6.ODO:
Thetotaldistancethatthisfunctionreferstofrombatterycapacityperiodruns.
7.PULSERATE:
PressMODEbuttonuntil"PULSE"appears.Beforemeasuringyourpulserate,pleaseplacethe
palmsofyourhandsonbothofyourcontactpadsandthemonitorwillshowyourcurrent
heartbeatrateinbeatsperminute(BPM)ontheLCDafter6~7seconds.
Remark:Duringtheprocessofpulsemeasurement,becauseofthecontactjamming,the
measurementvaluemaybehigherthanthevirtualpulserateduringthefirst2~3seconds,
thenwillreturntonormallevel.Themeasurementvaluecannotberegardedasthebasis
ofmedicaltreatment.
8.ALARM:
Thecomputerwill"Beep"whenpress"MODE","SET"and"RESET"buttons.
9.AUTOON/OFF&AUTOSTART/STOP:
Withoutanysignalfor4minutes,thepowerwillturnoffautomatically.Aslongasthewheel
isinmotionorpressanybutton,themonitorisinaction.
17
InstructionofMonitor