5.Routine Maintenance
Warning: Before cleaning or maintaining products, please be sure the power plug of the treadmill
is pulled out.
Cleaning: Comprehensive cleaning will extend the using life of the electric treadmill.
Remove dust periodically to keep the parts clean. Be sure to clean running belt with both sides of the
exposed part, which will reduce the accumulation of impurities. Make sure to wear clean athletic shoes
to avoid carrying the dirty matters into running board and belt. Treadmill belts shall be cleaned by a
damp cloth with soap. And please pay atte
ntion to avoid wetting the electrical components and running
belt.
Warning: Make sure power plug disconnect before moving motor cover away, clean the motor at least
once a year.
Running Belt Alignment
Put the treadmill flat on the ground. Make the treadmill run at a speed of 6-8km/hour.
If the running belt is closer to the left: rotate the left adjusting bolt with 1/2 turn clockwise, then
rotate the right adjusting bolt with 1/2 turn counter-clockwise. (Picture A)
If the running belt is closer to the right: rotate the right adjusting bolt with 1/2 turn clockwise, then
rotate the left adjusting bolt with 1/2 turn counter-clockwise. (Picture B)
Picture A: Belt closer to lef
t Picture B: Belt closer to right
E5
Over current protection:
In working, the lower
controller detects the
current to be over 6A for
more than 3 seconds.
Possible Cause:
Overloading leads to excessive current, and the system stops out of
self-protection, or some part is stuck, causing the motor to stop.
Adjust the treadmill and restart it. Check if there is liquid or burnt
smell while the motor is running, if yes, replace the motor; check if
the controller h
as a burned smell, if yes, replace the controller;
check the power supply voltage, if it does not match the
specifications, change into correct voltage, and test the machine
again.
E6
Explosion-proof impact
protection:the abnormal
voltage or motor cause
the faulty of circuit that
drive the motor.
Possible Cause:
Check if the power supply voltage is 50% lower than normal
voltage ，use the correct voltage and test the machine again；
check if the controller has a burnt smell and replace the controller;
Check if the motor cable is connected and connect the motor wire
again.
E7
No safety key Put the safety key on the right place.
Loosen
Loosen
Tighten
01
02 03 04 05 06 07 08 09 10 11
12
13 14 15 16 17 18 19 20
21 22
23
24 25 26 27 28 29 30 31 32 33
To Next Page
Loading...
