FAN INSTALLATION INSTRUCTIONS
• Make sure electricity is turned off at the main power box before commencing work. Turn off
the power by removing fuse or turning off circuit breaker before installing the fan and
replacing the lamps.
• The lowest point on the fan blade must be at least 2.1 metres (7 feet) from the floor.
• Make sure that ceiling joists are strong enough and of adequate size to support the weight of
the fan of about 35 kg.
1. Fan, hanger bracket and light kit must be
earthed during installation. Secure the
mounting bracket to the ceiling joist or
suitable piece of timber inserted between the
ceiling joists. The bracket should be attached
with two wood screws and washers supplied.
Remove covering plate on top housing by
loosening two screws. Insert one blade
through one of the slots on the side of motor
housing.
Align
blade holes with holes on blade
bracket. Secure the blade using screws and
fibre washers supplied. Repeat the same
step until all blades are installed.
Secure covering plate by tightening the two
screws
To Next Page
Loading...
