FAN INSTALLATION INSTRUCTIONS
LAMP REPLACEMENT
• Make sure electricity is turned off at the main power box before commencing work. Turn off
the power by removing fuse or turning off circuit breaker before replacing the lamps.
HOW TO INSTALL WALL CONTROLLER
• Do not mount wall controller near heat producing equipment.
• Wall controller provided is designed to be connected with the ceiling fan supplied in this
package only. Other uses may cause personal injury or fire hazard.
• Use of wall/remote controller other than those approved by MERCATOR will void warranty.
• Make sure electricity is turned off at the main power box before commencing work. Turn off
the power by removing fuse or turning off circuit breaker before installing the wall/remote
controller.
1. Disconnect the power and remove the existing wall plate and switch (if any).
2. Set the speed control knob on the wall controller in the off position.
3. Tighten screws on the terminal blocks; make sure wire connections are wired correctly and
secure.
4. Secure the wall controller to the wall with two screws provided.
To Next Page
Loading...
