171
Controls in detail
Control system
왘 Press button æ or ç to select
manual operation (
manual
) or daytime
running lamp mode (
constant
) activat-
ed.
With daytime running lamp mode activated
and the exterior lamp switch at
position M or U, the low beam
headlamps are switched on when the en-
gine is running.
In low ambient light conditions the follow-
ing lamps will switch on additionally:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
For more information on the daytime run-
ning lamp mode, see “Lighting”
(
컄 page 141).
Setting locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
position U, the following lamps will
switch on during darkness when the vehi-
cle is unlocked using button Πon the
SmartKey or SmartKey with
KEYLESS-GO*:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
앫 Front fog lamps
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey, the lamps
will switch off automatically after approxi-
mately 40 seconds.
왘 Move the selection marker with
button æ or ç to the
Lighting
submenu.
i
For safety reasons, resetting the
Lighting
submenu to factory settings
while driving (
컄 page 164) will not de-
activate the daytime running lamp
mode.
The following message appears in the
multifunction display:
Lighting - Can-
not be completely reset to factory
settings while driving.
컄컄
To Next Page
Loading...
Need help?
General
