set the exterior mirror such that the
rear wheel and curb are visible.
X
Press memory button M ? and one of
the arrows on adjustment button =
within three seconds.
The parking position is stored if the
exterior mirror does not move.
If the mirror moves out of position, repeat
the steps.
Calling up a stored parking position
setting
X
With the key in position 2 in the ignition
lock and the exterior mirror on the front-
passenger side activated, engage reverse
gear.
The exterior mirror on the front-passenger
side moves to the stored parking position.
The exterior mirror on the front-passenger
side moves back to its original position:
R
as soon as you exceed a speed of 6 mph
(10 km/h)
R
about ten seconds after you have
disengaged reverse gear
R
if you press button : for the exterior
mirror on the driver's side
Memory functions
Storing settings
With the memory function, you can store up
to three different settings, e.g. for three
different people.
The following settings are stored as a single
memory preset:
R
position of the seat, backrest and head
restraint
R
active multicontour seat: dynamic function
level
R
driver's side: steering wheel position
R
driver's side: position of the exterior
mirrors on the driver's and front-passenger
sides
G
Warning!
The memory function can still be used when
the key has been removed. For this reason,
children should never be left unsupervised in
the vehicle. They could otherwise become
trapped when adjusting the seat or the
steering wheel.
G
Warning!
Only use the memory function on the driver's
side when the vehicle is stationary. You could
otherwise be distracted from the traffic
conditions by the steering wheel and seat
moving of their own accord, and as a result
cause an accident.
X
Adjust the seat (Y page 104).
X
On the driver's side, adjust the steering
wheel (Y page 111) and the exterior mirrors
(Y page 113).
X
Press memory button M and one of the
storage position buttons 1, 2 or 3 within
three seconds.
The settings are stored in the selected
preset position. A tone sounds when the
settings have been completed.
Calling up a stored setting
X
Press and hold the relevant storage
position button 1, 2 or 3, until the seat,
steering wheel and exterior mirrors are in
the stored position.
Memory functions
115
Seats, steering wheel and mirrors
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 115
Z
To Next Page
Loading...
Need help?
General
