Model designation: 0872, DT/UW 200077 - IBK-
LK2P
MB part no.: A 000 583 9204
complies with the following relevant regulations:
2014/30/EU
Applied harmonised standards, in particular:
DIN EN 55014-1: 2017
DIN EN 55014-2: 2015
Manufacturer: Dunlop Tech GmbH
Address: Oenbacher Landstrasse. 8, 63456
Hanau
Authorised representative: IMS dept.
Date: March 2020
Signature: IMS-AE, IMS-AE-L
Diagnostics connection
The diagnostics connection is a technical inter-
face in the vehicle. It is used, for example, within
the scope of repair and maintenance work or for
reading out vehicle data by a specialist workshop.
Diagnostic devices should therefore only be con-
nected by a qualied specialist workshop.
&
WARNING Risk of accident due to con-
necting devices to the diagnostics con-
nection
If you connect devices to the diagnostics con-
nection of the vehicle, the function of vehicle
systems and operating safety may be
impaired.
#
For safety reasons, we recommend that
you only use and connect products
approved by your Mercedes-Benz service
centre.
&
WARNING Risk of accident due to objects
in the driver's footwell
Objects in the driver's footwell may impede
pedal travel or block a depressed pedal.
This jeopardises the operating and road safety
of the vehicle.
#
Stow all objects in the vehicle securely
so that they cannot get into the driver's
footwell.
#
Always t the oor mats securely and as
prescribed in order to ensure that there
is always sucient room for the pedals.
#
Do not use loose oor mats and do not
place oor mats on top of one another.
*
NOTE Battery discharging from using devi-
ces connected to the diagnostics connec-
tion
Using devices at the diagnostics connection
drains the battery.
#
Check the charge level of the battery.
#
If the charge level is low, charge the bat-
tery, e.g. by driving a considerable dis-
tance.
Please also note the information about the 12 V
battery and short-distance trips in the "Driving
and Parking" chapter (/ page 193).
General notes
33
P223 0288 02