Merck Spectroquant Prove 600 - First power-on; Language setup; Date, time and country-specific settings

Version 1.1 – 10/2015
11
4
5
2
1
3 Getting started – 3.2 Initial setup
3
3.2.2 First power-on
Afterswitchingonthespectrophotometerforthe󹭯rsttimeyou
are automatically guided through the language, date and time
setup procedures (see below).
1. Press the ON / OFF button
1
. The spectrophotometer gives
an audible signal (beep) and starts booting for approximately
2 minutes. You will see the following display:
1
2. The display switches to language setup (see Section 3.2.3).
3.2.3 Language setup
The software supports several languages. When you switch
onthespectrophotometerforthe󹭯rsttime,alistoflanguage
options is automatically displayed after the boot procedure.
1. Select the desired language
1
.
2. Tap on the Save button
2
tocon󹭯rm.
NOTE
The saving process of changing the language requires some
seconds.
3.2.4 Date,timeandcountry-speci󹕽csettings
During initial setup, having set the language option you are
automatically guided through the date and time setup procedure.
1
1. Tap on the date format button
1
.
2
1