Section 8 - Customer Assistance Information
Page 140 90-8M0053363 eng NOVEMBER 2010
Outside the United States and Canada
Contact your nearest dealer or Marine Power Service Center for information on additional literature that is available for your
particular Mercury MerCruiser power package and how to order that literature.
Print or type your mailing address, which be used as your shipping label, and include your order and payment. Mail to:
Mercury Marine
Attn: Publications Department
W6250 West Pioneer Road
P.O. Box 1939
Fond du Lac, WI 54936-1939
USA
Dealer Checklist and Customer Orientation
Contact Information
Dealer name and number
Dealer technician or salesperson's name
Customer name
Customer phone number
TVM Dealer
Inspect the starboard TVM steering clevis pin. ☐
Inspect the port TVM steering clevis pin. ☐
Engine Dealer
Inspect the starboard hydraulic steering fluid reservoir level. ☐
Inspect the port hydraulic steering fluid reservoir level. ☐
Helm Dealer
Inspect the joystick. ☐
Inspect the steering wheel and tilt mechanism. ☐
Inspect the VesselView, if equipped. ☐
Inspect the Axius trackpad, if equipped. ☐
Wet Test Dealer
Confirm vessel personality list. ☐
Ensure the steering wheel returns to center position during key "ON" of starboard engine. ☐
Perform IMU (compass) calibration and zero heading correction. ☐
Maneuver the boat to port by moving the joystick to full port. Ensure undesirable movement can be corrected by
minimal operator joystick input.
☐
Maneuver the boat to starboard by moving the joystick to full starboard. Ensure undesirable movement can be
corrected by minimal operator joystick input.
☐
Ensure vessel tracks a straight course at cruising speed. Perform drive alignment if required. ☐
Enable AutoHeading and drive for one minute at cruising speed ensuring less than (± 5) degree deviation to port
or starboard.
☐
Check steering response by steering boat from lock to lock at different speeds, starting at idle and accelerating
through cruising speed in 1000 RPM increments.
☐
Perform a hard starboard turn at in‑gear idle while increasing to WOT while in turn. Ensure boat steering remains
responsive.
☐
Perform a hard starboard turn at in gear idle with both engines running. Turn the starboard engine off during the
turn. Ensure boat steering remains responsive.
☐
To Next Page
Loading...
Need help?
General
