MAINTENANCE
SECTION 5
Page 86 CMD-3967823 / 90-865237030 OCTOBER 2003
2. If flushing the engine with the boat out of the water:
WARNING
When flushing, be certain the area around propeller is clear, and no one is standing
nearby. To avoid possible injury, remove propeller.
a. Remove the propeller. Refer to boat manufacturers’ instructions.
b. Using an appropriate adapter, connect the flushing hose from a water tap to the
seawater inlet hose on the seawater pickup pump inlet.
79463
a
b
c
d
a-Adapter
b-Flushing hose
c-Water tap
d-Seawater pickup pump
c. Proceed to Step 3.
3. Partially open the water source to about 1/2 maximum. Do not use full water pressure.
CAUTION
Engine overheating can cause engine damage. To avoid, observe the water
temperature gauge and ensure the engine is operating in the normal ranges.
To Next Page
Loading...
Need help?
General