1. Remove and replace filter as follows:
a. Turn ignition key switch to "OFF" position.
b. Disconnect wire at bottom of filter.
c. Remove filter by turning the filter clockwise. Tip the filter to drain fluid in a suitable container.
d. Lubricate the sealing ring on the filter with oil. Thread on the filter and tighten securely by hand.
Reconnect the wire to the filter.
Steering Link Rod Fasteners
IMPORTANT: The steering link rod that connects the steering cable to the engine must be fastened using special
washer head bolt ("a" - Part Number 10-849838) and self-locking nylon insert locknuts ("c" & "d" - Part Number
11-826709113). These locknuts must never be replaced with common nuts (non-locking) as they will work loose
and vibrate off freeing the link rod to disengage.
WARNING
Disengagement of a steering link rod can result in the boat taking a full, sudden, sharp turn. This potentially
violent action can cause occupants to be thrown overboard exposing them to serious injury or death.
To Next Page
Loading...
Need help?
General