OPERATION
45
2. Open fuel tank vent on manual venting type tanks.
ob00348
NOTE: The engine will not start unless the lanyard is set to the "RUN" position.
3. Set the lanyard stop switch to the "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
ob00350
4. Shift outboard to neutral (N) position.
F
N
R
3417
NOTE: The engine can be started by using the ignition key or the start/stop button located on the remote control
panel.
5. Ignition key starting ‑ Turn the ignition key to "START" position and release the key. The electronic starting
system will automatically crank the engine for starting. If the engine fails to start, the engine will stop
cranking. Turn the key to "START" position again until engine starts.
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
3485
6. Start/stop button ‑ Turn the ignition key to "ON" position and press start/stop button and release. The
electronic starting system will automatically crank the engine for starting. If the engine fails to start, the
engine will stop cranking. Press start/stop button and release again until engine starts.
To Next Page
Loading...
Need help?
General