2. Start the engine.
3. Press the INFO button repeatedly until the Compass and Odometer
are displayed. (Do not select Trip, DTE, or AFE. The top of the message
center must be blank).
Note: If message center displays the message ⬙SLOW CIRCLES TO
CALIBRATE⬙, then continue with Step 4. Otherwise, if a heading is
displayed, continue with Step 5.
4. Drive the vehicle in circles up to
three times until the message
⬙CALIBRATION COMPLETED⬙
appears and one of the 8 valid
headings (N, NE, E, SE, S, SW, W,
NW) is displayed.
5. Verify that the calibration process has taken place by driving the
vehicle in at least one circle, confirming that the heading changes
accordingly. If this happens, the compass has been calibrated
successfully. Otherwise, if the display shows only one heading as the
vehicle is being driven around, repeat the procedure from Step 3.
Setup menu
Press this control for the following
displays:
• Language
• Units (English/Metric)
• System Check
Language
1. Select this function from the
SETUP menu for the current
language to be displayed.
2006 Montego (mgo)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
74
To Next Page
Loading...
Need help?
General
