INSTALLATION
134 eng
When first determining transom strength, use a dial torque
wrench. If the bolt or nut continues to turn without the torque
reading on the dial increasing, it is an indication that the transom
is yielding. The load area can be increased by using a larger
washer or a transom reinforcement plate.
NOTE: The inside holes on the transom reinforcement plate are
for the lower transom bolts and the outside holes are for the
upper transom bolts.
a - Large transom washer
b - Transom reinforcement plate
Description Part Number
Large transom washer 67‑896392
Transom reinforcement plate 67‑896305
To Next Page
Loading...
