Need help?Do you have a question about the Mercury 10 EFI FourStroke and is the answer not in the manual?
General| Displacement | 209 cc |
|---|---|
| Fuel System | EFI (Electronic Fuel Injection) |
| Shaft Length | 15" |
| Cooling System | Water-cooled |
| Starting System | Electric |
| Steering | Tiller |
| Full Throttle RPM Range | 5000 - 6000 RPM |
| Alternator Output | 6 Amp |
| Recommended Fuel | 87 Octane |
| Weight | 42 kg (92.6 lbs) |
| Exhaust | Through propeller hub |
Operator's duty for safe boat operation and occupant safety.
Stops engine when operator moves away; ensure it's in good condition.
Reduce speed in shallow or hazardous areas; control speed to avoid damage.
Alerts for overheat, low oil pressure, sensor faults, overspeed, and restrictor issues.
Essential checks before starting the engine for safe operation.
Crucial steps for breaking in the engine to ensure longevity and performance.
Step-by-step guide for starting the engine using tiller controls.
Step-by-step guide for starting the engine using remote controls.
Routine checks and maintenance tasks required before each use and at intervals.
Procedure for flushing cooling passages with fresh water after use.
Procedures for draining, inspecting, filling, and recommending gearcase lubricant.
Common causes and solutions when the electric starter fails to engage.
Identifies issues preventing the engine from starting, from fuel to ignition.
Warning about exceeding maximum horsepower and its consequences.
Critical steps for securely mounting the outboard to the boat transom.
To Next Page