Mercury 25 EFI FourStroke - Page 151

INSTALLATION
eng 141
4. Loosen the bolt securing the control harness retainer
bracket.
a - Shift link, cotter pin retainer, and washer
b - Shift actuating lever, cotter pin retainer, and washer
c - Throttle actuating lever, cotter pin retainer, and washer
d - Shift link
e - Bolt securing harness retainer bracket
5. Remove the bolt securing the cable barrel retainer to the
cowl.
10127
6. Connect the remote harness to the engine harness
connector.
7. Route the harness below the shift actuating lever pin.
a
b
c
d
10114
e