Mercury 25 EFI FourStroke - Page 97

OPERATION
eng 87
2. Position the fuel line primer bulb so the arrow on the side of
the bulb is pointing up. Squeeze the fuel line primer bulb
several times until it feels firm.
27348
IMPORTANT: To prevent engine flooding, do not squeeze the
primer bulb after the engine has warmed up.
3. Set the lanyard stop switch to "RUN" position. Refer to
General Information ‑ Lanyard Stop Switch.
19791
4. Set the tiller handle grip to neutral start position.
F
F
R
R
NEUTRAL
START
NEUTRAL
START
10051
5. Models with gas assist tilt ‑ Position the tilt lock lever to the
lock position.
LOCK
FREE
10251