MAINTENANCE
eng 85
CHECKING POWER TRIM FLUID (SINGLE-RAM TRIM SYSTEMS)
1. Place outboard in the full down/in position.
or52
2. Check the fluid level in the trim pump reservoir. The level should be
between the "MIN" and "MAX" level marks on the reservoir.
3. If necessary, remove the yellow fill cap and add Power Trim and Steering
Fluid until the level in the reservoir reaches the "MIN" level mark. It is
acceptable to fill the reservoir beyond the "MIN" level mark, but do not
overfill past the "MAX" level mark.
Tube Ref
No.
Description Where Used Part No.
114
Power Trim and
Steering Fluid
Trim pump reservoir 92-858074K01
4. Trim the outboard down to bleed air out of the system. The fluid level may
drop. Add more Power Trim and Steering Fluid if necessary, but do not
overfill past the "MAX" level mark.
5. Replace the fill cap.
To Next Page
Loading...
