GENERAL INFORMATION
Page 1C-10 90-827242R02 FEBRUARY 2003
GEAR HOUSINGS
The following procedures should be used in refinishing gear housings. This procedure will
provide the most durable paint system available in the field. The materials recommended
are of high quality and approximate marine requirements. The following procedure will
provide a repaint job that compares with a properly applied factory paint finish. It is
recommended that the listed materials be purchased from a local Ditzler Automotive Finish
Supply Outlet. The minimum package quantity of each material shown following is sufficient
to refinish several gear housings.
Procedure:
1. Wash gear housing with a muriatic acid base cleaner to remove any type of marine
growth, and rinse with water, if necessary.
2. Wash gear housing with soap and water, then rinse.
3. Sand blistered area with 3M 180 grit sandpaper or P180 Gold Film Disc to remove paint
blisters only. Feather edge all broken paint edges.
4. Clean gear housing thoroughly with (DX-330) wax and grease remover.
5. Spot repair surfaces where bare metal is exposed with (DX-503) alodine treatment.
IMPORTANT: Do not use any type of aerosol spray paints as the paint will not properly
adhere to the surface nor will the coating be sufficiently thick to resist future paint
blistering.
6. Mix epoxy chromate primer (DP-90LF) with equal part catalyst (DP-402LF) per
manufacturers instructions, allowing proper induction period for permeation of the
epoxy primer and catalyst.
7. Allow a minimum of one hour drying time and no more than one week before top coating
assemblies.
8. Use Ditzler Urethane DU9300 for Mercury Black, DU34334 for Mariner Grey, and
DU35466 for Force Charcoal, and DU33414 for Sea Ray White. Catalyze all three colors
with Ditzler DU5 catalyst mixed 1:1 ratio. Reduce with solvents per Ditzler label.
CAUTION
Be sure to comply with instructions on the label for ventilation and respirators.
Using a spray gun, apply one half to one mil even film thickness. Let dry, flash off
for five minutes and apply another even coat of one half to one mil film thickness.
This urethane paint will dry to the touch in a matter of hours, but will remain
sensitive to scratches and abrasions for a few days.
9. The type of spray gun used will determine the proper reduction ratio of the paint.
IMPORTANT: Do not paint sacrificial zinc trim tab or zinc anode.
10. Cut out a cardboard plug for trim tab pocket to keep paint off of mating surface to
maintain good continuity circuitry between trim tab and gear housing.
To Next Page
Loading...
Need help?
General
