GENERAL INFORMATION
Page 1C-12 90-827242R02 FEBRUARY 2003
DECAL APPLICATION
1. Mix 16 ml (
1
/
2
ounce) of dish washing liquid in 4 literes (1 gallon) of cool water to use
as wetting solution.
NOTE: Leave protective masking, if present, on the face of decal until final steps of decal
installation. This will ensure that the vinyl decal keeps it’s shape during installation.
2. Place the decal face down on a clean work surface and remove the paper backing from
adhesive side of decal.
3. Using a spray bottle, flood the entire adhesive side of the decal with the pre-mixed
wetting solution.
4. Flood area where the decal will be positioned with wetting solution.
5. Position pre-wetted decal on wetted surface and slide into position.
6. Starting at the center of the decal, lightly squeegee out the air bubbles and wetting
solution with overlapping strokes to the outer edge of the decal. Continue going over the
decal surface until all wrinkles are gone and adhesive bonds to the cowl surface.
7. Wipe decal surface with soft paper towel or cloth.
8. Wait 10 - 15 minutes.
9. Starting at one corner, carefully and slowly pull the masking off the decal surface at a
180° angle.
NOTE: To remove any remaining bubbles, pierce the decal at one end of the bubble with
stick pin and press out the entrapped air or wetting solution with your thumb (moving toward
the puncture).
To Next Page
Loading...
Need help?
General
