2. Center the shift cable anchor pin with the neutral detent alignment mark.
a - Shift cable anchor pin
b - Neutral detent alignment mark
3. Locate the center point of the slack or lost motion that exists in the shift
cable as follows:
a. Move the remote control handle from neutral into forward and advance
the handle to full speed position. Slowly return the handle back to the
neutral position. Place a mark "a" on the cable against the cable end
guide.
b. Move the remote control handle from neutral into reverse and advance
the handle to full speed position. Slowly return the handle back to the
neutral position. Place a mark "b" on the cable against the cable end
guide.
To Next Page
Loading...
