Mercury Boulevard Series - Page 10

E L E C T R I C B I C Y C L E M A N U A L – B O U L E V A R D S E R I E S
Page 10
3. E-bike Unpacking and Assembly
Put the kickstand in the down position to keep the bike stationary. Place the knurled part of the handlebar into the stem faceplate
and tighten the screws with an Allen key.
A. Make sure that the screws are all evenly tightened, and that there is an even gap on the top and the bottom of the stem
faceplate.
B. Ensure that the handlebar is perfectly centred and set to the desired angle.
symmetry
symmetry