Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE Propeller shaft 92-802859A 1
IMPORTANT: To prevent the propeller hub from corroding and seizing to the
propeller shaft (especially in saltwater), always apply the recommended
lubricant to the entire propeller shaft at the recommended maintenance
intervals, and also each time the propeller is removed.
7. Flo‑Torq I drive hub propellers ‑ Install forward thrust hub, propeller,
continuity washer, rear thrust hub, propeller nut retainer, and propeller nut
onto the shaft.
a - Propeller nut
b - Propeller nut retainer
c - Rear thrust hub
d - Continuity washer
e - Propeller
f - Forward thrust hub
8. Flo‑Torq II drive hub propellers ‑ Install forward thrust hub, replaceable
drive sleeve, propeller, rear thrust hub, propeller nut retainer, and
propeller nut onto the shaft.
a - Propeller nut
b - Propeller nut retainer
c - Rear thrust hub
d - Propeller
e - Replaceable drive
sleeve
f - Forward thrust hub
9. Place a block of wood between the gearcase and propeller and tighten
the propeller nut to the specified torque.
Description
Nm lb‑in. lb‑ft
Propeller nut 75 – 55
MAINTENANCE
eng 63
To Next Page
Loading...
Need help?
General
