Mercury L4NA 115 - Page 81

3. Disengage the tilt support bracket, by raising the outboard up and rotating
the tilt support lever up. Lower the outboard.
a - Tilt support lever
b - Tilt support bracket
MANUAL TILTING
If the outboard cannot be tilted using the power trim/tilt switch, the outboard can
be manually tilted.
28497
NOTE: The manual tilt release valve must be tightened before operating the
outboard to prevent the outboard from tilting up during reverse operation.
Turn out the manual tilt release valve three turns counterclockwise. This allows
manual tilting of the outboard. Tilt the outboard to the desired position and
tighten the manual tilt release valve.
a
b
28922
FEATURES AND CONTROLS
eng 71