4. Remove the power trim fill cap. The fill cap only requires 1/4 turn to
remove.
a - Tilt support lever
b - Power trim fill cap
c - Tilt support bracket
d - Pedestal
5. The fluid level should be approximately 25 mm (1 in.) from the top of the
fill neck. Add Quicksilver or Mercury Precision Lubricants Power Trim and
Steering Fluid. If not available, use automotive automatic transmission
fluid (ATF).
Tube Ref
No.
Description Where Used Part No.
114
Power Trim and
Steering Fluid
Power trim system 92-858074K01
6. Install the power trim fill cap. Tighten fill cap 1/4 turn. Cap will snap in
place. Do not tighten beyond this point.
To Next Page
Loading...
