STARTING SYSTEM SERVICE MANUAL NUMBER 23
Page 4A-32 90-861326--1 MARCH 1999
4. Push pinion back toward commutator end to eliminate slack.
5. Measure distance between pinion and pinion retainer.
6. If clearance is not within limits of .010-.160 in. (0.25-4.00 mm), it may indicate excessive
wear of solenoid linkage, shift lever yoke, or improper assembly of shift lever mecha-
nism. Replace worn or defective parts, since no provision is made for adjusting pinion
clearance.
72077
a
b
c
a-Pinion
b-Retainer
c-Feeler Gauge
Downloaded from https://needmanual.com/!
To Next Page
Loading...
