a - Anode - Bigfoot b - Anode - Standard
Steering Link Rod Fasteners
IMPORTANT: The steering link rod that connects the steering cable to the engine must be fastened using special
washer head bolt ("a" - Part Number 10-849838) and self-locking nylon insert locknuts ("b" & "d" - Part Number
11-826709113). These locknuts must never be replaced with common nuts (non-locking) as they will work loose
and vibrate off freeing the link rod to disengage.
WARNING
Disengagement of a steering link rod can result in the boat taking a full, sudden, sharp turn. This potentially
violent action can cause occupants to be thrown overboard exposing them to serious injury or death.
a - Special washer head bolt (10-849838)
b - Nylon insert locknut (11-826709113)
c - Flat washer (2)
d - Nylon insert locknut (11-826709113)
Assemble steering link rod to steering cable with two flat washers and nylon insert locknut. Tighten locknut until it
seats, then back nut off 1/4 turn.
To Next Page
Loading...
