4. Inflate the air floor to minimum 700 mb, maximum 825 mb. Quicksilver
double action pump is recommended for inflation of the air floor. DO NOT
use a compressed air source unless it is outfitted with a pressure
regulator set to 825 mb.
5. Inflate the keel.
6. Close the valves inserting the caps and turning them to the right.
IMPORTANT: Never exceed these values.
• Inflate the boat to 0.25 bar = 3.6 psi
• Inflate the keel to 0.4 bar
• Inflate the high‑pressure bottom to 0.8 bar
Slatted Floor Installation
Instructions for installing floorboards in Quicksilver models with a slatted floor.
The slatted floor of your Quicksilver boat has already been installed. You only
need to inflate the tubes in order to prepare your boat.
Slide Drain Valve
The Quicksilver Tendy, Airdeck, SPORT and SPORT HD series are equiped
with a slide drain valve. When underway, slide the drain to open position and
the water will automatically run out. The inner diaphragm will prevent water
from returning. After the water has been drained, slide the drain to the closed
position.
ASSEMBLY AND DISASSEMBLY
20 eng
To Next Page
Loading...
Need help?
General
