Mercury Quicksilver Series - Valves and Inflation

b. Push the sides of the floorboard under the tubes as far as possible.
d
d
66480
4. Inflate the air floor to minimum 700 mb, maximum 825 mb. Quicksilver
double action pump is recommended for inflation of the air floor. DO NOT
use a compressed air source unless it is outfitted with a pressure
regulator set to 825 mb.
5. Inflate the keel.
6. Close the valves inserting the caps and turning them to the right.
66482
IMPORTANT: Never exceed these values.
• Inflate the boat to 0.25 bar = 3.6 psi
• Inflate the keel to 0.4 bar
• Inflate the high‑pressure bottom to 0.8 bar
Valves
The Quicksilver valves are especially designed for safe and comfortable use.
The valves are designed flat to increase the comfort in the boat and to prevent
damage to the boat.
OPERATION
30 eng