OPERATION OF THE VALVE
Remove the outside cap. The valve is closed when the middle screw is in the
upside position. Push the valve once to open it. Push the valve again to close
it.
PUMP CONNECTION
Put the end piece (the part that must be turned) of the pump on the valve. Turn
to the right (clockwise) and start pumping. Keep pumping until the
recommended pressure is reached. When ready, be sure to remove the pump.
Be sure to put on the protection cap again (for protection from dirt and
damage).
ROWING EQUIPMENT
Quicksilver boats come standard with two paddles or with two oars, oarlocks,
and a wooden seat. Ensure the bench is properly installed. The oars should be
used in the oarlocks. To install the oars in the oarlocks, remove the cap from
the stainless steel pin, insert the oar, then replace the cap on the pin.
If the oars are not in use, put the oars in the clips on the sides of the boat, with
the blade pointing to the transom.
SEATS AND BENCHES
You must install the seat before fully inflating the boat. Inflate the boat to 75%
and install the seat.
When the seat is installed, the Quicksilver inflatable boat can be fully inflated.
OPERATION
eng 35
To Next Page
Loading...
Need help?
General