-A28-
1. Adjusting the Pressure for Feeding
The machine is already well set for proper feeding pressure. However, according to
different strap characteristics (such as smoother surface or different thickness), some
adjustments for feeding pressure are still necessary.
If short feed problem happens a lot, and it is a result of improper feeding pressure,
please do the following adjustments:
Loosen Nut B and turn Nut A clockwise to increase the feeding pressure. Or loosen
Nut A and turn Nut B counterclockwise to decrease the feeding pressure. After
adjustments, be sure to tighten these 2 Nuts well.
2. Adjusting the Pressure for Reversing
The machine is already well set for proper reversing pressure. However, according to
different strap characteristics (such as smoother surface or different thickness), some
adjustments for reversing pressure are still necessary.
If machine often has incomplete reversing problem, and it is a result of improper
reversing pressure, please do the following adjustments:
Take out the part (TA-073 Spring Hook) from C position to B or A position in order to
increase the reversing pressure.
C
B
A
To Next Page
Loading...