-A33-
Weekly:
Lubricate (front bar, press bar and rear bar) and shifts in arch weekly.
Please refer to the following mesh areas for instruction.
Before lubricating, be sure to clean the parts first to avoid mixing oil and debris which might
have a bad effect on machine’s function.
Test strapping with several bundles, paying attention to audible and visible failures and
check for correct function.
Monthly :( or 100,000 strapping cycles)
Clean both sides of heater plate and polish with fine sandpaper if necessary
ATTENTION: Make sure the welding plate is cool first!!
Check supporting and cam rollers of seal head for easy movement. The pressure plate must
be moved back to home position automatically by the spring tension.
Be sure to clean any debris in the tension roller
Air
To Next Page
Loading...