Mercusys MS105GP User Manual

This is a class A product. In a domestic environment, this product may cause radio interference,
in which case the user may be required to take adequate measures.
CE Mark Warning
BSMI Notice
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮，請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。
請不要私自拆開機殼或自行維修，如產品有故障請與原廠或代理商聯繫。
警告：為避免電磁干擾，本產品不應安裝或使用於住宅環境。
限用物質含有情況標示聲明書
單元
Ｕnit
PCB
外殼
電源供應器
其他及其配件
限用物質及其化學符號
備考1.〝超出0.1 wt %〞及〝超出0.01 wt %〞係指限用物質之百分比含量超出百分比含量基準值
Note 1：“Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the percentage content of
the restricted substance exceeds the reference percentage value of presence condition.
備考2.〝○〞係指該項限用物質之百分比含量未超出百分比含量基準值。
Note 2：“○” indicates that the percentage content of the restricted substance does not exceed
the percentage of reference value of presence.
備考3.〝－〞係指該項限用物質為排除項目。
Note 3：The “－” indicates that the restricted substance corresponds to the exemption.
○ ○ ○ ○ ○
鉛
Lead
(Pb)
○
○
-
-
汞
Mercury
(Hg)
○
○
鎘
Cadmium
(Cd)
○
○
六價鉻
Hexavalent
chromium
（Cr
+6
）
○
○
多溴聯苯
Polybrominated
biphenyls
(PBB)
○
○
多溴二苯醚
Polybrominated
diphenyl ethers
(PBDE)
○
○
○ ○○○○
Explanation of the symbols on the product label
Note: The product label can be found at the bottom of the product (and its .I.T.E power supply).
Direct current
For indoor use only
RECYCLING
This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be
handled pursuant to European directive 2012/19/EU in order to be recycled
or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling
organization or to the retailer when he buys a new electrical or electronic
equipment.
Polarity of d.c. power connector
Energy eciency marking (level VI)
Class II equipment
Caution
Operator’s manual
Alternating current
Wall Mounting Specications
4#, (5#), 6#, 8#
Screw Standard of
ANSI B1.1
4#, (5#), 6#, 8#
MS105GP
Model
MS106LP
4#, (5#), 6#
4#, (5#), 6#
MS108GP
MS110P
7mm
Minimum Length
of Screw
7mm
7mm
7mm
1.5mm
Screw-Head-to-Wall
Minimum Distance
1.5mm
1.5mm
1.5mm
39mm
Wall-Mounting-Holes
Distance
39mm
105mm
105mm
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам
нормативних документів та вимогам, що передбачені чинними законодавчими актами України.
The POE output cannot be used to charge lithium batteries or devices with lithium batteries.

Mercusys MS105GP Specifications

General

Total Power over Ethernet (PoE) budget	65 W
Power over Ethernet (PoE) ports quantity	4
10G support	No
Networking standards	IEEE 802.3af, IEEE 802.3at, IEEE 802.3x
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	5
Power source	DC
AC input voltage	220 V
AC input frequency	50 Hz
Power consumption (max)	75.15 W
Power consumption (typical)	3.13 W
Jumbo frames	9
MAC address table	2000 entries
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Cables included	AC
Switch type	-
Certification	CE, RoHS
Product color	Black
Housing material	Metal
Transmission distance (max)	0.1 km

Weight and Dimensions

Depth	98 mm
Width	99.8 mm
Height	25 mm