Merit 710B - Important Precautions; General Safety Warnings; Children and Pets Safety; Usage Environment and Weight Limit

BEFORE
YOU BEGIN
6
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
BIKE
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
7
INTRODUCTION
IMPORTANT
PRECAUTIONS
BIKE
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
FRONT FOOT TUBE
BOLTS (A)
MAIN FRAME
ASSEMBLY S T E P 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT FOOT TUBE to the MAIN FRAME using 2 BOLTS (A).
C) Attach REAR STABILIZER to the SEAT SLIDE TUBE using 2 WASHERS (C), 2 SPRING WASHERS (B) and 2 BOLTS (D).
D) Insert caps into the tube ends.
BOLT (A)
Qty: 2
SPRING WASHER (B)
Qty: 2
WASHER (C)
Qty: 2
BOLT (D)
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
TOOLS INCLUDED PARTS INCLUDED
c 5mm Allen Wrench
c 13/15mm Flat Wrench
c Phillip Screwdriver
c 5mm T Wrench
c 6mm T Wrench
c 1 Console
c 1 Console Mast
c 1 Front Stabilizer Tube
c 2 Pedals
c 1 Top Shroud
c 1 Seat Slide Tube
c 1 Seat Back
c 1 Seat Base
c 4 Hardware Bags
c Manual Resistance Knob (710B Only)
c 1 Rear Stabilizer
c 1 Seat Support Tube
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
CONSOLE (710B SHOWN)
MAIN FRAME
SEAT ADJUSTMENT POSITION LEVER
FRONT STABILIZER TUBE
RESISTANCE KNOB (710B ONLY)
HANDLEBARS
PEDALS
TOP SHROUD
MAST BOOT
BOLTS (D)
WASHERS (C)
SPRING WASHERS (B)
REAR STABILIZER SEAT SLIDE TUBE
710B_720B_Rev.1.7.indd 6-7 8/28/06 3:31:40 PM