4
Introduction
Thank you for selecting the CleanTech® 2000S & 4000S Automated Hand Cleansing System, with Boot
Sanitizing Pan option, as a component in your handwashing regimen. We designed the Series 2000S &
4000S to provide your facility with an automated, turnkey system that meets or exceeds your hand
cleansing requirements for compliance, standardization and effectiveness. The addition of the Boot
Sanitizing Pan saves valuable employee time and increases boot sanitizing contact time for the best in
footwear hygiene.
This manual describes everything you will need to properly site, install, and maintain your Boot Sanitizing
Pan System attached to the CleanTech system. Please refer to the separate CleanTech® 2000S or 4000S
Installation operation manual for set up and installation of those handwashing systems.
The CleanTech 2000S w/ Boot Sanitizing Pan will fit into an area that accommodates 23" width X 42"
depth footprint and will hook-up to your existing, standard hot/cold water lines and wall drain for the
handwasher. However, in addition, you will need a floor drain for the boot pan. A more detailed
description of the installation procedure can be found in the Installation Guide of this manual.
The CleanTech 4000S w/ Boot Sanitizing Pan will fit into an area that accommodates 60” width x 42”
depth foot print and will hook-up to your existing, standard hot/cold water lines and wall drain for the
handwasher. In addition, you will need a floor drain for the boot pans. A more detailed description of
the installation procedure can be found in the Installation guide of this manual.
Select an area for installation that is level and encourages frequent use in your facility. We recommend
positioning the CleanTech system either near the main work area, lunch facilities, restroom facilities, or
close to the entrance and exit doors.
CleanTech 2000S (left) and 4000S (right) Systems with Boot Sanitizing Pan(s)
To Next Page
Loading...
