To Next PageTo Next Page
Need help?Do you have a question about the Merlin PowerGuard PRO and is the answer not in the manual?
General| Product Type | Surge Protector |
|---|---|
| Frequency Range | 50/60 Hz |
| Outlets | 8 |
| Cord Length | 6 feet |
| Maximum Load Capacity | 15A |
| Response Time | Less than 1 nanosecond |
| Protection Features | Overload Protection, Short-Circuit Protection |
| Operating Temperature | 32°F to 104°F |
| Weight | 1.5 lbs |
Details placement of CPU, contactors, and switches for optimal installation.
Specifies the continuous and cranking current ratings for the contactors.
Guidance on locating contactors near batteries and proper high-power cable termination.
Instructions for CPU placement in dry areas and switch mounting on panels.
Details connecting the ignition inhibit wire to prevent system issues.
Identifies loads that should bypass flat battery protection and be fused separately.
Explains how to adjust disconnect voltage (B1/B2) and time delay via trim-pots.
Provides recommended voltage and time delay settings for engine and auxiliary batteries.
Details the 2-year warranty period and what defects are covered.
Outlines Merlin's options for repair or replacement of defective products.
Provides contact information for troubleshooting and warranty service requests.
