PRODUCT: Mermade Pro Waver
22mm/25mm/32mm
MODEL NUMBER/S: MH5000 MH5001 MH5002
MH5003 MH5004 MH5005 MH5006 MH5007
MH5008 MH5009 MH5010 MH5011 MH5014
MH5019 MH5035 MH5020 MH5030 MH5022
MH5031 MH5032 MH5033 MH5012
MATERIAL: Ceramic Tourmaline
HEATER: 3*PTC heater
MIN TEMP: 80°C/180°F
MAX TEMP: 210°C/ 410°F
VOLTAGE: Dual Voltage
LINE LENGTH: 2.5M
AS WITH MOST ELECTRICAL MACHINES, ELECTRICAL
PARTS ARE ELECTRICALLY LIVE EVEN WHEN THE
SWITCH IS OFF. TO REDUCE THE RISK OF BURNS, FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS:
1. Always unplug appliance immediately after using.
An appliance should never be left unattended when
it is plugged in.
2. Do not use while bathing or sleeping.
3. Do not place or store the machine where it can fall
or be pulled into a tub or sink.
4. Do not place in or drop in water or any other liquid.
5. If the tool falls into water, unplug it immediately.
Do not reach into the water.
6. Use this appliance only for its intended use as
described in this manual. Do not use attachments not
recommended by manufacturer.
7. Always place the appliance with the safety stand on
a heat-resistant, stable flat surface.
8. Never operate this appliance if it has a damaged
cord or plug, if it is not working properly, if it has been
dropped or damaged, or if it has been
dropped into water.
9. Keep cord away from the heated surfaces. Do not
wrap the cord around the appliance.
10.Do not use an extension cord. This appliance is not
intended for use by persons under the age of 12
years old, unless supervised by an adult.
ATTENTION
1. It is recommended this appliance should not be
used by persons who have reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they are supervised by a person
responsible for their safety.
2. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
3. Do not use this appliance near bathtubs, showers,
basins or other vessels containing water.
4. Keep appliance out of reach from young children,
particularly during use and cool down.
5. Never leave appliance unattended when it is
connected to a power supply. Always place the
appliance with the safety stand on a heat-resistant,
stable flat surface.
6. Do not use on wet, damp or synthetic hair.
7. For additional protection, the installation of a
residual current device (RCD) having a rated residual
operating current not exceeding 30mA is advisable in
the electrical circuit supplying the bathroom. Ask
your installer for advice.
8. Always do a strand test before using on your hair
as heat can affect some hair colour, in particular on
freshly coloured or toned hair
MAINTENANCE
1. To clean the unit, be sure the unit is cool and
unplugged. Wipe the handle and barrels with a damp
cloth. No other maintenance is necessary.
2. Do not attempt to repair the appliance yourself.
This appliance has no user serviceable parts.
3. Unplug the unit whenever it is not in use. Allow it
to cool, then store it out of reach of children in a safe,
dry location.
4. Never wrap the cord around the appliance, since
this will cause the cord to wear prematurely and
break, thus voiding warranty. Handle the cord
carefully and avoid jerking, twisting, or straining it,
especially at plug connections.
SAFETY
1. Take extra care to ensure the hot plates do not
contact skin or eyes.
2. Use a mirror when using the appliance to assist
with safe usage.
3. Do not place tool on surfaces that are not heat
resistant.
4. Polythene bags over the product and packaging
may be dangerous. To avoid danger of suffocation,
keep away from babies and children. These bags are
not toys.
5. This appliance may not be treated as household
waste. It should be handed to an appropriate
collection point for the recycling of Electrical
and Electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and
human health, which could otherwise be caused by
inappropriate waste handling
of this product. For more detailed information about
the recycling of this product, please contact
To Next Page
Loading...