PAGE 8
FrONT PANeL: CO N T r O L S & Fe A T u r e S (Continued)
CONTOUR: (Cont.)
maximum, the EQ effect becomes extreme and a realm of sounds that are hard to believe appear.
Tight, percussive lows and rich layers of chirping upper harmonic expression make the sound and feel dangerously addictive to
play. The possibilities are almost limitless when you combine the sonic personalities of the four Modes with the versatility and
power of the CONTOUR feature. Be sure to spend some time in each of the Modes exploring this inspiring frontier of sounds.
STANDBY:
Perfect for set breaks...this toggle switch also serves an even more important purpose. In the STANDBY position (switch
up), the tubes are at idle so that during power up they may warm up before being put to use.
Before the power is switched on, make sure the STANDBY switch is in the STANDBY position. Wait at least
30 seconds and then flip the STANDBY switch to its ON position. Following this simple warm up procedure helps in
preventing tube problems and increase their toneful life substantially.
POWER:
This switch delivers the A.C. power to the Express. Make sure the unit is properly grounded ( all three terminals of the A.C.
power cord must be connected whenever possible and that the proper voltage is present. Follow the cold start procedure described
in the ON/STANDBY section above when powering up your new Express amplifier.
NOTE: Never alter the A.C. power cord in any way.
Now let’s spin your Express around and cover the Rear Panel Features.
To Next Page
Loading...
Need help?
General
