PAGE 5
CONTROLS:
(Continued)
Use this toggle to select one of the three Modes - RHYTHM, LEAD or CONTOUR. For the channel select Footswitch to operate, the
channel select toggle must be in the LEAD (center) position.
Perfect for set breaks...this toggle switch also serves an even more important purpose. In the STANDBY position the tubes are at idle
so that during power up they may warm up before being put to use. Before the Power is switched on, make sure the STANDBY
switch is in the STANDBY position. Wait at least 30 seconds and then flip the STANDBY to the
ON position. This helps in preventing tube problems and increases their toneful life substantially.
This switch delivers the A.C. power to the ROCKET 44. Make sure the unit is grounded (all three terminals of the A.C. power cord
must be connected whenever possible and that the proper voltage is present. Follow the cold start procedure described in the ON /
STANDBY section above when powering up your ROCKET 44.
TOGGLE SWITCHES:
RHYTHM / LEAD / CONTOUR:
ON / STANDBY:
ON
ON
POWER
STANDBY
RHYTHM
CONTOUR
F
T
S
W
L
E
A
D
POWER:
ON
ON
POWER
STANDBY
RHYTHM
CONTOUR
F
T
S
W
L
E
A
D
REST AREA
ON
ON
POWER
STANDBY
RHYTHM
CONTOUR
F
T
S
W
L
E
A
D
To Next Page
Loading...
