7I92 32
REFERENCE INFORMATION
LBP16
MEMORY SPACE 6 LAYOUT:
ADDRESS DATA
0014 LEDMode If LSb is 0, LEDs are "owned" by HostMot2,
otherwise LEDs are local debug LEDs
0016 DebugLEDPtr What variable in space 6 local debug LEDs show
(default is RXPktCount).
0018 Scratch Can be used for sequence numbers
001A EEPROMWEna Must be set to 5A0N to enable EEPROM or flash
writes or erases (N is memory space of
EEPROM or flash) Note that this is cleared at
the end of every packet.
001C LBPReset Setting this to a non-zero value will do a full
reset of the LBP16 firmware. The 7I92 will read
its IP address jumpers and re-assign its IP
address. The 7I92 will be unresponsive for as
much as ½ of a second after this command.
001E FPGAICAP FPGA ICAP-16 register to allow remote FPGA
reload and other low level FPGA access.
ERROR REGISTER FORMAT
BIT ERROR
0 LBPParseError
1 LBPMemError
2 LBPWriteError
3 RXPacketErr
4 TXPacketErr
5 HM2TimeOutError
6..15 Reserved
To Next Page
Loading...